An investigation of operating conditions on anodic oxidation of synthetic sulfide-containing wastewaters at the surface of a platinum electrode using cyclic voltammetry

Document Type : Research Paper

Authors

1 Fuel Cell Laboratory, Green Research Center, Iran University of Science and Technology (IUST), Tehran, Iran

2 Schools of Chemical Engineering, Iran University of Science and Technology (IUST), Tehran, Iran

3 Research Institute of Petroleum Industry (RIPI), Tehran, Iran

Abstract

In this paper, cyclic voltammetry (CV) was used to study the effects of operating parameters (i.e., sulfide concentration, sodium chloride concentration as supporting electrolyte, temperature, mixing speed, and potential scan rate) on the anodic oxidation of synthetic sulfide-containing wastewaters at the surface of a platinum electrode. The results revealed that anodic oxidation could be used to eliminate sulfide from wastewaters in a wide concentration range, and the oxidation current was an ascending function of the sulfide concentration. The supporting electrolyte concentration had a negligible effect, as the sulfide dissociated in the aqueous media and brought electrical conductivity to the solution. The optimum concentration of electrolyte was found to be 0.05 mol/L. Increasing temperature improved the kinetics of the oxidation reactions and enhanced the electrical conductivity of the solution, which resulted in increasing the anodic oxidation rate. However, at higher temperatures, undesired side reactions were activated which resulted in lowering the power efficiency of the desired anodic oxidation reactions. The optimum operating temperature was found to be 40 – 60 °C. The mixing speed had a periodic effect on the sulfide oxidation. It decreased the diffusion resistance and also the residence time of sulfide at the electrode surface. These phenomena affected the anodic oxidation oppositely and hence, a middle value around 200 rpm was found to be the optimum. By increasing the potential scan rate, the time of performing the reactions in each cycle increased and the overall oxidation progress improved. It was found that mass transfer resistance was a limiting step in the overall reaction. Based on the findings, anodic oxidation has the potential for treating sulfide-containing wastewaters and in the future may be a competitor for conventional treatment processes.

Keywords

Main Subjects


[1] Pikaar, I., Likosova, E. M., Freguia, S., Keller, J., Rabaey, K., Yuan, Z. (2015). Electrochemical abatement of hydrogen sulfide from waste streams. Critical reviews in environmental science and technology, 45(14), 1555-1578.
[2] Churchill, P., Elmer, D. (1999). Hydrogen sulfide odor control in wastewater collection systems. Journal of the New England water environment association, 33(1), 57-63.
[3] Robert, P. G., Bowker, A. G. A. (1991). Hydrogen sulfide corrosion: its consequences, detection and control. United States environmental protection agency, Washington, DC.832-S-91–100.
[4] Bowker, R. P. G., Smith, J. M., Shah, H. J., Flaherty, P. A., 1991. Hydrogen sulfide corrosion in wastewater collection and treatment systems. United States environmental protection agency, Washington, DC.
[5] Strickland, J., Cummings, A., Spinnato III, J. A., Liccione, J. J., Foureman, G. L. (2003). Toxicological review of hydrogen sulfide. United States environmental protection agency, Washington, DC.
[6] Rankin, K., Bejan, D., Bunce, N. J. (2010). Electrochemical oxidation of the sulfide ion in synthetic geothermal brines in batch cells using coke electrodes. Industrial and engineering chemistry research, 49, 6261-6266.
[7] Talei, M., Mowla, D., Esmaeilzadeh, F. (2015). Ozonation of an effluent of oil refineries for COD and sulfide removal. Desalination and water treatment, 56(6), 1648-1656.
[8] Mattiusi, E. M., Kaminari, N. M. S., Ponte, M. J. J. S., Ponte, H. A. (2015). Behavior analysis of a porous bed electrochemical reactor the treatment of petrochemical industry wastewater contaminated by hydrogen sulfide (H2S). Chemical engineering journal, 275, 305-314.
[9] Vaiopoulou, E., Provijn, T., Prévoteau, A., Pikaar, I., Rabaey, K. (2016). Electrochemical sulfide removal and caustic recovery from spent caustic streams. Water research, 92, 38-43.
[10] Rajalo, G., Petrovskaya, T. (1996). Selective electrochemical oxidation of sulphides in tannery wastewater. Environmental technology, 17(6), 605-612.
[11] Särkkä, H., Kuhmonen, K., Vepsäläinen, M., Pulliainen, M., Selin, J., Rantala, P., Sillanpää, M. (2009). Electrochemical oxidation of sulphides in paper mill wastewater by using mixed oxide anodes. Environmental technology, 30(9), 885-892.
[12] Kienow, K. K., Amy, G. L., Bryant, C., Glasgow, D., Hoffman, H., Keller, J., Knopf, W., Lanyon, R., Oleszkiewicz, J. A., Pomeroy, R. D., Ponte, M., Randall, C. W., Redner, J., Rolen, T., Rogers, E., Schafer, P., Schultz, S., Tchobanoglous, G., 1989. Sulfide in wastewater collection and treatment systems, American society of civil engineers, New York.
[13] Nemerow, N. L., Agardy, F. J. (1998). Strategies of industrial and hazardous waste management. John Wiley and sons.
[14] AECOM, 2010. Petroleum refining water/wastewater use and management, IPIECA, London, United Kingdom.
[15] Ellis, C. E., Lawson, R. J., Brandenburg, B. L., Environmental, Z. (1994, March). Wet air oxidation of ethylene plant spent caustic. In 6th annual ethylene producers conference.
[16] Maugans, C., Howdeshell, M., De Haan, S. (2010). Update: Spent caustic treatment. Hydrocarbon processing, 89(4), 61-61.
[17] Cheremisinoff, N. P. (2002). Handbook of water and wastewater treatment technologies Butterworth. Heineman, Boston USA, 404, 138-140.
[18] Gogate, P. R., Pandit, A. B. (2004). A review of imperative technologies for wastewater treatment I: oxidation technologies at ambient conditions. Advances in environmental Research, 8(3-4), 501-551.
[19] Gogate, P. R., Pandit, A. B. (2004). A review of imperative technologies for wastewater treatment II: hybrid methods. Advances in environmental research, 8(3-4), 553-597.
[20] Chen, G. (2004). Electrochemical technologies in wastewater treatment. Separation and purification technology, 38(1), 11-41.
[21] Radjenovic, J., Sedlak, D. L. (2015). Challenges and opportunities for electrochemical processes as next-generation technologies for the treatment of contaminated water. Environmental science and technology, 49(19), 11292-11302.
[22] Mook, W. T., Aroua, M. K., Issabayeva, G. (2014). Prospective applications of renewable energy based electrochemical systems in wastewater treatment: A review. Renewable and sustainable energy reviews, 38, 36-46.
[23] Barrera-Díaz, C., Cañizares, P., Fernández, F. J., Natividad, R., Rodrigo, M. A. (2014). Electrochemical advanced oxidation processes: an overview of the current applications to actual industrial effluents. Journal of the Mexican chemical society, 58(3), 256-275.
[24] Martinez-Huitle, C. A., Ferro, S. (2006). Electrochemical oxidation of organic pollutants for the wastewater treatment: direct and indirect processes. Chemical society reviews, 35(12), 1324-1340.
[25] Anglada, A., Urtiaga, A., Ortiz, I. (2009). Contributions of electrochemical oxidation to waste‐water treatment: fundamentals and review of applications. Journal of chemical technology and biotechnology, 84(12), 1747-1755.
[26] Lam, V., Li, G., Song, C., Chen, J., Fairbridge, C., Hui, R., Zhang, J. (2012). A review of electrochemical desulfurization technologies for fossil fuels. Fuel processing technology, 98, 30-38.
[27] Caliari, P. C., Pacheco, M. J., Ciríaco, L. F., Lopes, A. (2017). Anodic oxidation of sulfide to sulfate: effect of the current density on the process kinetics. Journal of the Brazilian chemical society, 28(4), 557-566.
[28] Tsonopoulos, C., Coulson, D. M., Inman, L. B. (1976). Ionization constants of water pollutants. Journal of chemical and engineering data, 21(2), 190-193.
[29] Zavodnov, S. S., Kryukov, P. A. (1960). The value of the second dissociation constant of hydrogen sulfide. Russian chemical bulletin, 9(9), 1583-1585.
[30] Archer, M. D. ,(1989) Genesis of the Nernst equation, in: Stock, J. T., Orna, M. V. (Eds.), Electrochemistry, Past and present, American chemical societ, 115–126.
[31] Asadi, A. A., Bazmi, M., Alavi, S. M., Royaee, S. J. (2016). Neutralization of NaAlO2 solution with CO2 for synthesis of γ-Al2O3 nanoparticles, Part 1: Effects of synthesis parameters in semi-batch membrane dispersion microstructured reactor. RSC Advances, 6(111), 109681-109691.
[32] Gosser, D. K. (1993). Cyclic voltammetry: simulation and analysis of reaction mechanisms (Vol. 43). New York: VCH.